Parts for a leather built Clone Trooper Belt, this lightweight and durable approach makes assembling a belt much simpler and straightforward! The base belt only weighs about 8 oz.
The belt utilizes a 60" leather base with magnetic fasteners to secure the belt boxes in place. Blocks on the boxes prevent them from spinning or rotating. A 3/4" leather punch will be necessary to cut holes for where you want your belt boxes to go. A center line is drawn on the belt to help with belt box placement. ONLY THE CENTER 8 HOLES ARE PRE-PUNCHED. The magnetic fasteners MUST be pointed upwards for the best results. 12 sets of magnetic fasteners are included but will need glued in place.
The belt includes a tab to connect the back sides but is left un-connected for custom fitting - if you decide to shorten the belt. The ends are connected by 2 clips on the thermal detonator.
The magnetic fasteners fit into pre-modeled holes featured in the Belt V5 files here: https://bit.ly/3V8um6D
The belt boxes can be included as raw 3d prints, they are not sanded/smoothed/painted. The front 2 large boxes are able to open and are hollow inside! 2 versions of a rear belt box are included, one for RotS and one for Battlefront 2.
Different colors are available as well. The leather is colored with a leather dye and includes care instructions to preserve the finish.
Magnetic fasteners are a SNAP Small Sewable Male and Female combo.
2 rubber casted sets of ridges are included in the selected color.
Please allow 3–4 weeks for your order to be made and shipped. Each piece is made to order, and times may vary slightly depending on current workload.
