A DIY kit of raw 3d printed parts for a Halo Bandit Rifle
Printed in pre-separated parts and needing assembled.
Please refer to the materials needed to complete this kit none of which are included:
Spring Kit: https://amzn.to/4bcu708
- Uses the 9/32” x 2-13/16” expansion spring for the slide
- Uses the 9/32” x ¾” compression springs for the trigger
2mm diameter metal rods: https://amzn.to/3HxS985
- Used to pin the spring in place at 1 end
5mm diameter metal rod: https://amzn.to/4bgpTVa
- Used to strengthen the pull
10 x 3mm magnets: https://amzn.to/3HHmktD
- Uses 4 to hold the magazine in place
Uses a ½” diameter wooden dowel down the center
- Available at most large grocery/craft stores
- 85cm length and 80cm length
